Skip to main content

Con Edison Demand Charge: Why Restaurants Pay So Much

By Meltek TeamNovember 16, 20264 min read

Con Edison bills SC 9 restaurants on their busiest half hour: $34.50 per kW, or $44.05 per kW from June through September. Here is why NYC kitchens pay so much for it and how to cut the peak.

A Con Edison demand charge bills the highest load your restaurant pulls, averaged over your busiest half hour of the billing period. On SC 9 Rate I it is $34.50 per kW from October through May and $44.05 per kW in summer. Kitchens fire ovens, fryers and hoods together before a rush, so a short spike sets a big charge.

What is a Con Edison demand charge?

A demand charge bills your peak, not just your total use. Con Edison's tariff says your maximum demand "shall be the highest 30-minute integrated demand occurring during the billing period" (General Rule 10.4). In plain terms, your peak is your busiest half hour of the billing period, averaged. A single rushed half hour in a NYC kitchen can set the charge for the whole bill.

What does Con Edison charge per kW of demand?

On Con Edison's SC 9 Rate I low-tension service, the demand delivery charge is $44.05 per kW of your maximum demand in June, July, August and September, and $34.50 per kW in all other months. Energy delivery is $0.0154 per kWh, and a customer charge of $72.00 per month is added on top. Supply charges and other delivery adjustments are separate.

Not every Con Edison account pays for demand. Service Classification 2 is for businesses whose requirements do not exceed 10 kW, and its standard rate, SC 2 Rate I, bills a customer charge and energy use with no demand charge. Service Classification 9 is for businesses whose requirements are expected to exceed 10 kW. Check the rate class printed on your bill.

How much does a busy half hour cost a restaurant?

Here is the math with Con Edison's SC 9 Rate I delivery charges, outside summer. At $34.50 per kW, say your restaurant's highest demand on the bill is 40 kW. Your demand charge is then $1,380. Now, at $0.0154 per kWh, say the same bill shows 15,000 kWh of use. Energy delivery comes to $231. From June through September, the same 40 kW peak costs $1,762 at $44.05 per kW. In this NYC example, the peak costs far more than the energy delivery.

What cutting your peak takes off the demand charge on each SC 9 Rate I bill, in this example:

  • Cut your peak by 5 kW: $172.50 from October through May, $220.25 from June through September.
  • Cut your peak by 10 kW: $345 from October through May, $440.50 from June through September.

Why is the demand charge so big for restaurants?

Restaurants use a lot of power in a few hours. PNNL researchers say food service buildings use about 5 to 7 times more energy per square foot than conventional commercial buildings. In NYC kitchens, ovens, fryers, dish machines, hoods and air conditioning can easily start in the same half hour. Con Edison bills that spike, even if the rest of the billing period is quiet.

Meal rushes make it worse. Lunch and dinner are when every station in a NYC kitchen runs at once, so either rush can set your Con Edison peak for the whole billing period.

How can a restaurant lower its Con Edison demand charge?

Each kW you cut from your peak takes $34.50 off a Con Edison SC 9 Rate I bill from October through May, and $44.05 from June through September. Before NYC lunch and dinner rushes, don't start the ovens, fryers, dish machine and air conditioning in the same half hour. Stagger them by 30 minutes or more, so their warm-up loads don't land in the same half hour Con Edison measures. Slow hood fans in quiet periods with demand-controlled kitchen ventilation.

Where should a NYC restaurant start?

Start with your last Con Edison bill and find your peak demand and your rate class. Then run our bill savings check. Our small business page explains how Meltek works with NYC shops and restaurants. For more steps, read How to Lower a Con Edison Bill for Your NYC Restaurant.

What is the demand charge on a Con Edison bill?

It is a charge on your maximum demand in the billing period, which Con Edison's tariff defines as the highest 30-minute integrated demand. On SC 9 Rate I low-tension service it is $44.05 per kW from June through September and $34.50 per kW in all other months.

Do small restaurants pay a Con Edison demand charge?

Not always. Service Classification 2 is for businesses whose requirements do not exceed 10 kW, and its standard rate bills energy use with no demand charge. Service Classification 9 is for businesses expected to need more than 10 kW. Check the rate class printed on your bill.

How much can cutting peak demand save a restaurant?

Each kW you trim from your peak takes $34.50 off an SC 9 Rate I bill from October through May, and $44.05 from June through September. In our example, a 10 kW cut saves $345 outside summer and $440.50 in summer.

Sources

  1. Con Edison, P.S.C. No. 10 - Electricity: General Rule 10.4, Maximum Demand (Leaf 84, Revision 1); Service Classification No. 2 (Leaf 396, Revision 3); Service Classification No. 9 (Leaf 444, Revision 3) and its Rate I charges (Leaf 445, Revision 22, effective 02/01/2026).
  2. PNNL, Food Service Building Asset Rating Methodology and Analysis (Goel, Gonzalez Matamoros, Vlachokostas and Wang, 2018).
Business